Technology Database: Energetics
Energetics: technologies, equipment and decisions
for a power complex; alternative sources of energy; power-saving
technologies; household and industrial sources of heat and energy.
Consumer electric convector
of a new type
The consumer electric convector is designed for
creation of a heated air flow in rooms of different types; is convenient
to heat living quarters and utility rooms (repair shops, warehouses,
etc.).
UVE 0.5 and UVE 1 wind-driven
plants
The UVE 0.5-1 wind-driven plants can be easily
disassembled and transported, which makes them especially promising
for use in field conditions involving frequent change of site (by
geologigists, prospectors, hunters and others).
VEU 16-30 wind-driven plant
It operates in an off-line mode of direct connection
to load. To impart higher stability to the VEU 16-30 structure,
needed, for example, at installation on loose ground, it is possible
to deploy the generator and reduction gear on the ground, which
significantly enhances the stability of the plant and makes its
tech-nical maintenance easier.
Hydroelectric Micro plants
& Hydrounits
Hydroelectric micro plants are reliable, ecologically
friendly, compact, fast paying-off sources of electric power for
villages, steads, suburban settlements, farms, as well as mills,
bakehouses, small manufactures and tourist complexes in remote and
hard-to-reach regions.
Slow-Speed Wind Power Plant
The slow-speed wind power plant is designed for
transformation wind energy to electric one. The plant is effective
for use in different natural-climatic zones including those where
medium wind speed does not exceed 4-5 m/s.
Vortex whirl-wind energetic
installation
The vortex whirl-wind energetic installation (WWEI)
serves to convert power wind and of swirling air flows into electric
power.
HIGH-PERFORMANCE
LOW-CALORIE FUEL HEAT-GENERATOR
The heat-generator is intended for processing of
timber wastes or other low-calorie fuel with the purpose to obtain
heated air or water, or water steam, as well as to generate electric
power.
BURNERS OF vortex REVERSE-FLOW
TYPE
The devices are intended for ignition of combustion
mixture and stabilization of combustion in combustion chambers of
gas-turbine engines, vehicles and gas-pumping stations operating
in extreme conditions.
Wind power
plant
Is intended for conversion of wind energy into
electricity. Is used as an independent or stand-by power supply
source in areas remote from centralized electric power supply systems
(small farms, cooperatives, grassland ranges, microirrigation systems)
and with average annual wind velocities over 3.5 m/s.
Infra-red heater
Is designed to heat different rooms. Due to heat transfer by a specific band of the light beam, it provides heating that is natural and safe.
Mobile oil refinement plant POUM-1
Pumping, heating, adsorption, filtration and vacuum storage of refined transformer oil and other insulating fluids used in oil-filled equipment.
Arc protection sensor with enhanced jam-resistance DD3-2
The sensor is designed for protection of high-voltage switches and complete distribution cabinets (CDC) with voltage of over 5 kV.
Heater of oil NM-4
Heating and primary purification of transformer and turbine oils and other insulating and lubricating fluids. It can be used for rapid and soft heating of oil in winter conditions before the first starting of the transformers and other oil-filled plants in the course of preventive maintenance, as well as before vacuum degassing and refinement of oil.
|
